0 Items - £0.00
Coronavirus (COVID-19) We continue to operate a full service with procedures in place to follow government guidelines to help protect the safety of our staff and customers.

Hotpoint Washing Machine Showing Fault Code: F05

Hotpoint Washing Machine Showing Fault Code: F05

Fault: Hotpoint washing machine showing fault code: F05 = Waste pipe blockage or pump issue.

Initial repair: Pull the grey ribbed pipe off of the spigot under the sink and place it in a bowl or bucket. Put the machine onto a spin/drain cycle and check to see if the water drains into the bucket or bowl.
If the machine is pumping into the bucket/bowl then the issue may be with your plumbing, if it is not then it is a potential blockage in the machine. See below:

If the above does not work: Pull the washing machine out, lean it back ~ 45°, remove plastic cover on bottom right of machine, place a towel and a bowl underneath the machine. Locate the black circular filter cap and remove this.
Inside the cavity please check for any obvious obstructions and ensure the impeller at the rear of cavity spins freely. Repeat the above instructions In reverse order and test the machine to see if it is working.

Still need help? Please send a message or call 01206 794905 to discuss with an agent.

Added by: Alistair Gorbutt

Added in: Washing Machine Support

Recently Added

My Washing Machine Smells Really Bad

My Washing Machine Smells Really Bad

Added by: Alistair Gorbutt

My Washing Machine Not Spinning Or Draining

My Washing Machine Not Spinning Or Draining

Added by: Alistair Gorbutt